QL Light Co.,Ltd is one of the leading China tape light manufacturers and suppliers with professional factory. Welcome to wholesale products from us. CRI≥90 Version: very suitable for the application that require high color rendering. It will give you a true color. Every Two LED can be cut:...
QL Light Co.,Ltd is one of the leading China tape light manufacturers and suppliers with professional factory. Welcome to wholesale products from us.
CRI≥90 Version: very suitable for the application that require high color rendering. It will give you a true color.
Every Two LED can be cut: the cutting length is only 3.33cm.
◆ LED Type: CRI90 SMD5050
◆ Input Voltage: DC24V
◆ Color: Red, Green, Blue, Yellow, Warm White, Nature White, Pure White
◆ LED Qty: 60LED/m
◆ Beam Angle: 120 degree
◆ IP Ratio: IP20, IP54. IP67 or IP68 Version
◆ IP20: Non-waterproof Version
◆ IP54: Single-Side glued with silicone
◆ IP67: With Silicone Tube
◆ IP68: With silicone tube and silicone glue
Color Rendering Testing Report:
Different IP version:
1. Decorative lighting for festivals, events, shows, exhibitions
2. Architectural lighting for canopy, corridor, window, archway,
3. Backlight or edge light for signage
4. Path or contour marking
5. Channel letter lighting
Copied from LED NEWS.ORG (www.lednews.org)
Suggestions for LED PCB design
POSTED ON SEPTEMBER 12, 2013 BY ADMIN IN LED COMPONENT, LED KNOWLEDGE WITH THERE ARE NO COMMENTS
In designing a circuit, the current through each LED must not exceed the absolute maximum rating specified for each LED. In the meanwhile, resistors for protection should be applied, otherwise sight voltage shift will cause big current change, burn out may happen.
It is recommended to use circuit A while regulates the current flowing though each LED rather than circuit B. When driving LEDs with a constant voltage in circuit B, the current through the LEDs may vary due to the variation in Forward voltage (VF) of the LED. In the worst case, some LED may be subjected to current that exceed absolute maximum rating.
Thermal design is paramount importance because heat generation may result in the characteristics decline, such as brightness decreased, color changed and so on. You should consider the heat generation of the LEDs when making the PCB design.